High performance engine tuning

Tuning at EngineLogics is done on an Eddy Current Dynamometer. Our all wheel DynoDyanmics Dyno, baptized by our customers as Betsy the Heart Breaker allows us not only to tune accurately for all conditions but also helps us diagnosing drivability issues.

With a bone crushing torque capability of 4500 ft/lb Betsy can measure 1800 HP on the rear wheels, 900 HP on the front wheels and 2400 HP combined. Peak Hold capability is 1200 HP on the rear and 600 HP on the front. Our all wheel dyno can handle front wheel drive, rear wheel drive, AWD, 4WD 2WD and single wheel drive.

Eddy Current dynamometers are currently the most common absorbers used in modern chassis dynos. The Eddy Current absorbers provide the engine tuner  with the quick load change rate for rapid load settling. Eddy Current dynamometers allow steady state and controlled acceleration rate operation, there counterparts allows for wide open throttle only.

A 24000 CFM air extraction system ensure for a continues quality air stream in the dyno room and therefore guarantee a proper tuning environment.

From high performance engine tuning too tuning for fuel efficiency and drivability, EngineLogics will take care of your engine tuning needs.

Tuning principles, does not deviate from model make or engine therefore our wide range of experience of tuning high performance engines.

EFILive | HP Tuners | SCT | EcuFlash (Open Source) | Hondata | Cobb AccesPort | Nissan GTR Cobb AccessPort | Osiris Uprev | Motec | Haltech | Link | Vi-Pec | AEM EMS | AEM FIC | Autronic | Power FC | Hydra Nemises | APex'I SAFC | ElectroMotive | Microtech| Stinger and others

Dyno Rates:

Contact us at 281-933-2262 to setup an apointment

Your dyno tuning checklist:

1. An appointment with a $150.00 deposit is required.
2. Make sure you have at least half a tank of fuel.
3. All tuning is done on unleaded fuel. (You will be required to purchase your own oxygen sensor if you want to be tuned on a leaded fuel)
4. If a tuner such as Cobb Access Port etc. is used, make sure that you bring the interface unit with you.
5. Bring any software you might have for your ECU’s application.
6. List all modifications.
7. Ensure all electrical connections are correct and make proper contact.
8. Check all fluid levels and top-off if required.
9. Check all charge piping and clamps are secured and tight.
10. Verify correct spark plug and gap.
11. Ensure that the tires are in good and safe operational condition and verify correct tire pressure
12. Be on time.

Contact EngineLogics, for the best alround tuning performance in Houston.

AEM Performance Engine Tuning
Cobb AccessPort Performance Tuning
EcuFlash Performance Tuning
EFILive Performance Tuning
Haltech Performance Tuning
Hondata Performance Tuning
HP Tuners: Ford and GM Performance tuning
Nissan UpRev Performance Tuning